Panels   Vacuum mould
  Frames   Vacuum machine
  Columns   Vacuum forming
  Doors   Fitting roundels
  Lobby   Door roundels


Site Map


Prev Next

The doors are a place where the lack of roundels has been rather obvious, so now I can add them...

Here they are "before"

I lit the roundels around the door in my console room, because they're the primary source of lighting. In the studio I imagine there was other lighting. I didn't want the console room to be dark over by the door.

... and "after"

During the Key to Time season (left), the doors had roundels, much like the walls. Later it looks like they were painted over to the wall colour, as seen in the picture at top. Rather than cut holes in my doors, I went for the later look. My console is slightly later than the Key to Time season anyway...

I was faced with the task of making the roundels round.

First I trimmed the edges very 
roughly on the table saw

Then I neatened them up with a belt sander

Here's the trimmed roundel 
looking, well, round

I sprayed them with primer, then painted them the wall colour

And stuck them on with hot glue

better, I think

Emergency lighting? Or just fiddling with the gamma correction in the photo editor?
It shows off the roundels nicely anyway.

Prev Next